Thermal Gas Mass Flow Meter Heat Exchanger

Product Description:

A Thermal Gas Mass Flow Meter installation is a device used to measure gas flow.  It uses the principle of heat conduction to determine the mass flow of the gas by measuring the cooling effect of the gas on the sensor. 

 Installing a thermal gas mass Flow Meter requires the following steps:  

  1. Determine the installation location: Choose a suitable location to install the flow meter, usually avoid vibration, temperature changes or corrosive gases.  

  2. Obtain installation materials: Obtain required installation materials, such as bolts, washers, and sealants.  

 3. Install the flow meter: Place the flow meter in the installation position and use bolts to fix it.  Make sure there is no gap between the flow meter and the pipe and use a sealant to seal it.  

  4. Connect the pipe: Use the appropriate pipe to connect the flow meter to the gas source and target position.  Make sure the pipe connection is strong and there are no leaks.  

  5. Electrical connection: According to the electrical connection requirements of the flow meter, connect it with the power supply and control system.  

  6. Calibration and testing: According to the flow meter instructions, calibration and testing to ensure its accuracy and stability.  

The above are the general steps for the installation of thermal gas mass flow meters, and the specific steps may vary according to different products.  During the installation, ensure that you refer to the installation manual and follow the safety regulations. Our company's electromagnetic flowmeter, Precession Vortex Flowmeter, Thermal Gas Mass Flowmeter and other products are very high measurement accuracy, balance flowmeter, Nozzle Flowmeter are often used, our products are also very professional.